Dynamic 1P2020C24 - 20x20x1 Polarized Media Air Cleaner
Dynamic 1P2020C24 - 20 "x 20" x 1" Polarized Media Air Cleaner Rheem 84-20X20-1
ImageCombining ease of installation with low static pressure (for lower energy consumption and system wear), 1” Dynamic Air Cleaners are high-efficiency whole-house electronic air cleaners with an equivalency rating of MERV 13. As tiny sub-micron particles and volatile organic compounds (VOCs) pass through the central heating and cooling system, they become polarized. The polarized particles get larger as they join together with other polarized particles and collect on a disposable low-static polarized media pad with an activated charcoal center screen. Dynamic
Air Cleaners remove difficult odors and provide an efficiency of 97% for particles down to .3 microns in size. 1” panels fit directly into existing filter racks or filter grilles and are powered using simple 24V wiring connected to the central HVAC system.
• Very high multiple pass efficiency (95-99% for particles of 0.3 to 0.5 micron size); rises as the air cleaner loads (confirmed by independent laboratories)
• Equivalency to MERV 13 rating on more traditional media filters
• Air cleaners fit directly into existing filter racks or return air grilles
• 24V power supply; optional transformer 84-110V-24V plugs directly into a 120V outlet
• 6000VDC output voltage to polarized media
• No ozone production
• Low static resistance to airflow; maximum recommended face velocity: 500 FPM
• Disposable carbon-filled media pads only require a few minutes to change; requires replacement every three to four months
• Custom sizes available
• Toll-Free NATE certified Technical Support 800.578.7873
• 5-year limited warranty
MERV, or Minimum Efficiency Reporting Value, is a number from 1 to 16 that is relative to air filter efficiency. The higher the MERV value, the more efficient the air filter is at removing particles. At the lower end of the efficiency spectrum a fiberglass panel filter may achieve MERV 4 or 5. At the higher end, filters that achieve MERV 13 or 14 are typically used in hospitals and clean rooms. High MERV filters are capable of removing higher quantities of extremely small contaminant (particles as small as 1/300 the diameter of a human hair). Higher MERV ratings can create problems with greater airflow resistance. This is also referred to as static pressure. With most filters the filter media becomes denser, and static pressure increase, as the filter efficiency increases. Increased static pressure forces the system fan motor to work harder as it pushes air through the filter. This also increases energy consumption. So for optimum performance, consumers should select the highest efficiency filter with the lowest static pressure.
What’s a micron?
Particle size is usually measured in microns, a metric unit of measure. A micron is 1/25,000 of an inch. There are over 20 million particles in the average cubic foot of indoor air.
Approximately 98% of all particles (by count) are in the size range of 5 microns or less. Visible particles
represent only a small fraction of particles found in indoor air.
|Eye of a needle||500 to 2000 microns|
|Grain of Sand||100 to 2000 microns|
|Human Hair||40 to 300 microns|
|Pollen||10 to 50 microns|
|Mold Spores||10 to 30 microns|
|Bacteria||.07 to 10 microns|
|Typical Dust||.01 to 10 microns|
|Paint Particles||.05 to 3 microns|
|Tobacco Smoke||.01 to 3 microns|
|Viruses||.001 to .01 microns|
|Replacement Media (3-Pack):||54-20X20-R|
Customers who bought this product also bought:
4 other products in the same category: